Our Project 996tt is still under the knife getting it’s power plant upgrades and new clutch installed. We thought we had everything we needed, but a $10.00 fuel fitting has put us a few days behind, the new fitting should be here tomorrow so that we can finish the installation and fire the car up in the next 1-2 days. A big thanks to Tony @ EPL for helping us with the fuel system and working on a prototype tune for the big injectors we’ll be running.

In the meantime we received a truck shipment from MA Shaw today that included our new wing and carbon fiber hood. The factory 996TT rear wing has a hydraulic system that raises and lowers the wing to provide down force at higher speeds. While the system works great, it does so at a cost of weight. We’ve been looking for ways to save weight in every portion of our building, so we opted for a new wing. We called MA Shaw in California to build us one of their track wings and lightweight hoods. Their wing is very similar to what you would see on a factory cup car, however it’s slightly smaller in size, and incorporates ducting for the air intake. We opted for GT3RS carbon fiber end plates to give the wing a bit more of a street look as well. We estimate a weight savings of 25-30lbs with the hood, and another 25-30 in the rear as well while improving down force. We also go the last of the parts needed for our GT2 front upgrade, I hope to tackle that tomorrow. Once the latest round of upgrades are complete we will re-weight the car and see where we’re at, more horsepower and less weight is never a bad thing.