Novitec Ferrari F430 project continues at Titan
Our Ferrari F430 project continues here at Titan Motorsports with the Novitec technicians progressing at a neck breaking pace. After a mere 2 and a half days of wrenching the supercharger install was complete and fired up with no problems. The sound of a Italian V8 with twin Superchargers is absolutely amazing, we’ll be putting the car on the dyno later this week, with video soon to follow. The engine bay received a host of carbon fiber, from the engine surround trim panels, to hand crafted intercooler pipes. The quality of the parts offered in this kit are second to none and it’s obvious after taking one look at the engine bay why Novitec is one of the leading Ferrari tuenrs in the world. Now that the car is up and running all that is left is to finish re-installing the factory components, install the KW/Novitec suspension and button up a few minor visual updates on the exterior.
The KW / Novitec Hydraulic lift coilovers where installed on the car today, improving the handling of the vehicle while also allowing the driver to raise the front end 44mm from inside the cabin. This was a much needed addition to this vehicle with it’s slammed stance and Novitec front lip leaving little room for clearance under the front bumper.
On the exterior we also replaced the factory bumper lights both front and rear with Novitec smoked LED units, as well as Novitecs black housing tail lights. Rather than just smoke the factory housings, Novitec went the extra mile and created custom black exterior housings, while leaving the reverse light clear for added safety. The car should be wrapped up tomorrow and get it’s change to exercise it’s extra ponies on our Dynojet 248, an event I’m anxious to report the results of, until then enjoy these latest pictures in the gallery below.